Relthoza Lights 'Clean-up'

[Phaedros]

Just wondering if someone has made a guide for drilling out and cleaning up the area underneath the legs of the Relthozan Lights?

[Duskland]

I can tell you what I did.

I drilled a hole under each leg with a 1/8th bit using a pin vice. I then drilled a hole on either side of it (in the corners of the space) using a 1/16th bit. I used an x-acto knife to trim the remaining material under the leg. You'll need to replace the blades quite often (the resin rapidly dulls them).

[kennyal]

I use a power drill to make a hole under the legs then move in a circular motion until enough of the resin is gone. Def wear some eye protection and a mask though.

[alamo]

OMG! you folks are REALLY patient. wish I had more.